Itel 5360 Firmware PAC Flash File Free Download
You can use an Itel 5360 Firmware PAC Flash file to update the device. You must make sure that the battery is above 50% before you start the process. First, download the device firmware with PAC flash file. Next, unzip it using WinRar or 7zip. Once the file is loaded into the phone, connect it to an spd upgrader tool. Write the firmware PAC with the spd upgrader tool. Do not write the file if your phone is on low battery mode.
You can use any tool to write this file. If you don’t have a flashing tool, you can download a PAC flash file support tool from online stores. Then, follow the instructions on the website to write the PAC FILE. Once the PAC files are written, the phone should restart. Once done, you can use the phone without any problems. You can then install the new firmware.
Uses Of Itel 5360 Firmware PAC Flash File
With itel 5360 PAC firmware using the spd upgrade tool, you can fix many issues on itel 5360 mobile device without any hustle, Among of the issue that have been tested with this tool to 100% fixed includes the followings
- illegal use power off
- invalid IMEI numbers
- hang on logo
- long booting
- death boot after writing the wrong firmware
- password lock remove
- privacy lock remove.
- Virus Attact
- Password Removed
- Auto Rebooting
- Full Signal but no calling
- Battery draining fast ( if the cause is software issue )
- Phone Hanging
- And much more…..
Itel 5360 Firmware PAC Flash File Free Download
Warning:
Before downloading, check the mobile phone id and firmware id, also use the spd upgrade tool minimum version to write the firmware PAC file. And do not write in low battery mode. Don’t interrupt during the process I mean while writing the file
- Downloads Information
- File size is 8.4MB
- id it5360-GC2809-EnFrPoArSwHa-20200529
- Free file complete.
How to flash Itelit 5360
- First, use the button above for Itel 5360 Firmware PAC Flash File Free Download
- Extract all files from zip or Rar files.
- Open the Itel Flash Tools folder and run the UpgradeDownload.exe file
- Then click the Load Packet button and select the PAC file from the specified flash file folder.
- Wait for a while until the file loads
- Then click the download button
- To connect your phone to the tool, put your phone in download mode.
- Turn off the phone, press the volume up and down at the same time, and press the plug-in data cable.
- Blinking starts waiting until the blinking occurs.
- During the flash, the data cable may not come out of the phone or the phone may be in dead mode.
Check Also:
